Panasonic WV-SW314 Przewodnik Instalacji Pobierz pdf (Strona 29)

z Be sure to view the monitor for adjustment when the camera angle is adjusted.

Supply power to this unit, connect the monitor for adjustment (e.g. a small LCD) to the monitor

output jack, and adjust the camera angle (turn off the power after view angle adjustment for safety).

q Loosen the 4 fixing screws of the front cover to remove the front cover.

w Connect the monitor output jack and the monitor for adjustment with the RCA pin cable

(locally procured).

<Frontcover>(ThisillustrationrepresentsWV-SW316.)

e Repeat the steps (1) and (2) to adjust the camera angle.

(1) Loosen the panning lock screw and rotate the camera head horizontally to adjust panning.

(2) Loosen the tilting lock screw and rotate the camera head vertically to adjust tilting.

(3) Tighten the panning lock screw and tilting lock screw after camera angle adjustment.

IMPORTANT:

 •

After camera angle adjustment, the panning lock screw and tilting lock screw shall be securely tightened.

Recommended tightening torque: 2.45 N·m {1.8 lbf·ft}

Tilting lock screw

Panning lock screw

Notes:

 • Useahexagonalwrenchwithwidthacrossflatsof4mm(locallyprocured)toloosenortighten

the panning lock screw and tilting lock screw.

 • Approximately1rotationoflooseningthepanninglockscrewandtiltinglockscrewallowscam-

era angle adjustment. Do not loosen the screws beyond necessity.

 • Thecamerabodyshallbeheldwhenthepanninglockscrewortiltinglockscrewisloosened.

 • Focus adjustment (

☞ page 30-32) shall be performed at the same time panning and tilting

adjustments are performed.

Adjustment

Fixing screw x4

Front cover

Monitor output jack

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 49 50

Brak uwag

Panasonic WV-SW314 Przewodnik Instalacji Strona 29