Panasonic EY4541 Instrukcja Użytkownika Pobierz pdf (Strona 8)

- 8 -

Adjusting the base

1. Use the hex wrench to loosen the

base fixing screw.

2. Move the base along the base ad-

justment hole to set its position. (See

the diagram at right.)

• The base can be adjusted to between

0° and 45° sideways and the for-

ward/back position can also be ad-

justed. If tilting the base sideways,

remove the dust cover first.

• Refer to the bevel index to determine

the angle.

• Rip fence fixing screw should be lo-

cated on the opposite side tool is bev-

eled.

3. Use the hex wrench to tighten the

base fixing screw.

Position of base and purpose of use

Base adjustment

hole position

Purpose of use

Normal right-angled

cutting

Cutting at an angle

between 0° and 45°

Cutting at an angle of

45°

Cutting close to the end

of a wall

NOTE:

This is only a rough guide. The ac-

tual angle of the cut will be affected

by factors such as the way the tool

is held against the surface.

3

2

1

0

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 175 176

Komentarze do niniejszej Instrukcji

Brak uwag