Panasonic WV-CW504 Przewodnik Instalacji Pobierz pdf (Strona 31)

Optional Heater Unit WV-CW5H (option)

Installing the heater unit enables the camera to operate in a low-temperature environment below

–30 °C. The heater turns on automatically when the temperature inside the camera drops below

+10 °C and turns off when the temperature rises. A small fan inside the unit will minimize conden-

sation on the surface of the enclosure caused by changes in ambient temperature unless tempera-

tures change too rapidly.

Important:

 • Whenusing12VDCpowersupply,theoptionalheaterunitisunavailable(WV-CW504).

 • Turningtheheateronandoffmaydisturbthecameraimages.

 • Thepowersupplyofthecamerashallbeturnedoffwhenmountingordismountingtheheater.

When servicing, pay attention to high temperature on the surface of the heater unit. Disconnect

the harness and wait until the heater unit cools.

 • Whenthecameraisinstalledandoperatedinlowtemperaturesbelow–10°C,normalimages

may not be obtained immediately after startup. In such a case, wait approxilately 60 minutes or

more.

How to install the heater unit

q Remove the camera’s enclosure and mount it in the specified position with the supplied screw.

w Connect the heater unit cable to the connector of the camera.

Important:

 • Aftermountingtheheaterunit,arrangetheharnesscableasshowninthedrawingsoasnotto

be tangled around the enclosure, safety wire, and equipment inside the camera.

Heater output connector

Screw for heater unit*

(supplied with heater unit)

* Two screws including a spare screw are

provided as the standard accessories.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 43 44

Brak uwag

Panasonic WV-CW504 Przewodnik Instalacji Strona 31