Panasonic WV-SC588 Przewodnik Instalacji Pobierz pdf (Strona 12)

Precautions for installation

This camera is designed to be used indoors.

This product is not operable outdoors.

Do not expose this camera to direct sunlight for hours and

do not install the product near a heater or an air condi-

tioner. Otherwise, it may cause deformation, discoloration

and malfunction. Keep this camera away from water and

moisture.

Power supply

This product has no power switch.

When turning off the power, turn off a power supply or

remove a power cable. When the power cable of the

product is connected to the power supply device, the

power will be supplied to the product. When the product

is supplied, the product will perform panning, tilting,

zooming and focusing.

Before cleaning the product, make sure that the power

cable is not connected to the main power supply.

Installation area for this product

Select an appropriate place for the installation area (such

as a strong wall or ceiling) in your particular environment.

 • Whentheinstallationareaisnotstrongenough,rein-

force and strengthen it or use an optional mount

bracket (WV-Q105 or WV-Q126A).

 • Whenthe productisinstalled onawall, usethewall

mount bracket (WV-Q119).

 • Do not mount the product on a plaster board or a

wooden section because they are too weak. If the

product is unavoidably mounted on such a section,

the section shall be sufficiently reinforced.

Do not place this product in the following places:

 • Locations where it may get wet from rain or water

splash (including under the eaves, etc.)

 • Locationswhereachemicalagentisusedsuchasa

swimming pool

 • Locationssubjecttomoistureoroilsmokesuchasa

kitchen

 • Locations that have a specific environment that is

subject to an inflammable atmosphere or solvents

 • Locationswherea radiation,anX-ray,astrongradio

wave or a strong magnetic field is generated

 • Locationswherecorrosivegasisproduced,locations

where it may be damaged by briny air such as sea-

shores

 • Locations where the temperature is not within the

specified range (☞ page 31)

 • Locations subject to vibrations, such as onvehicles,

marine vessels, or above product lines (This product

is not designed for on-vehicle use.)

 • Locations subject to condensation as the result of

severe changes in temperature

Mounting method for this product

This product is designed to be used as a pendant mount

camera. If the product is mounted on a desktop or at a

slant, it may not work correctly and its lifetime may be

shortened.

Procure fixing screws separately.

The screws that mount the camera mount bracket (acces-

sory) and other brackets on a ceiling or a wall are not sup-

plied. Prepare them according to the material and strength

of the area where the product is to be installed.

<Installing the unit directly on a ceiling using the camera

mount bracket (accessory)>

 • Requiredscrews:M4(4pcs.)

 • Minimumpull-outstrength:196N{44lbf}(per1pc.)

Screw tightening

 • The screws and bolts must be tightened with an

appropriate tightening torque according to the materi-

al and strength of the installation area.

 • Donotuseanimpactdriver.Useofanimpactdriver

may damage the screws or cause tightening exces-

sively.

 • Whenascrewistightened,makethescrewataright

angle to the surface. After tightening the screws or

bolts, perform checks to ensure that the tightening is

sufficient enough so that there is no movement or

looseness.

Make sure to remove this product if it will no longer

be used.

Radio disturbance

When this product is used near TV/radio antenna, strong

electric field or magnetic field (near a motor, a transformer

or a power line), images may be distorted and noise may

be produced.

PoE (Power over Ethernet)

Use a PoE hub/device that is compliant with IEEE802.3af

standard.

Router

When connecting this product to the Internet, use a

broadband router with the port forwarding function (NAT,

IP masquerade).

Refer to the Operating Instructions on the provided

CD-ROM for further information about the port forwarding

function.

Panasonic assumes no responsibility for injuries or property damage resulting from failures arising out of

improper installation or operation inconsistent with this documentation.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

Komentarze do niniejszej Instrukcji

Brak uwag

Panasonic WV-SC588 Przewodnik Instalacji Strona 12

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Kamery ochrony Panasonic WV-SC588