Panasonic CZ-ESWC2 Instrukcja Instalacji Pobierz pdf (Strona 29)

3-19-3. Wiring the ceiling panel

(1) Loosen the 2 screws on the electrical component box

lid, and remove the lid. (Fig. 3-80)

(2) Fasten the wiring connector (7P, red) which comes out

from the ceiling panel using the lead wire clamps

(2 locations) on the unit. Then connect it to the

connector (7P, red) inside the indoor unit electrical

component box. (Fig. 3-81)

If the connector is not connected, “P09” is displayed on

●

the remote controller, and the automatic ﬂ ap will not

operate. Be sure to securely connect the connector.

Check that the wiring connector is not pinched

●

between the electrical component box and the lid.

Check that the wiring connector is not pinched

●

between the indoor unit and the ceiling panel.

3-19-4. Installing the side panel and intake grille

A. Installing the side panel

(1) Grasp the side panel ﬁ nger grip and slide the panel in

the direction of the arrow to install the side panel.

(Fig. 3-82)

(2) Fasten the side panel onto the ceiling panel using the

supplied screws (4 × 12 or 5/32" × 15/32").

B. Installing the intake grille

To install the intake grille, follow the procedure for

●

removing it in the reverse order. (Fig. 3-83)

When installing the intake grille, be careful that the ﬂ ap

●

lead wire does not become pinched. (Fig. 3-83)

3-19-5. Others

A. Check after installation

Check again that there is no gap between the indoor

●

unit and the ceiling panel, or between the ceiling panel

and the ceiling surface.

* If there is a gap, then water leakage and

condensation may occur.

Check that the wiring connections are secure.

●

* If the wiring is not connected, the automatic ﬂ ap will

not operate. (“P09” is displayed on the remote

controller.) In addition, water leakage, condensation,

and other problems may occur.

B. If a wireless remote controller is used

For details concerning the installation procedure, refer

●

to the installation manual which was supplied with the

optional wireless remote controller and indoor unit

internal receiver.

Screws

Electrical component

box cover

Fig. 3-80

Electrical component box

Power supply outlet

Inter-unit control wiring

Fig. 3-81

Fasten with screws

Tab

Tabs

Slide

Slide the side panel so that the side panel tabs are fastened to

the ceiling panel. Then fasten in place with the supplied screws

(4 s12 or 5/32" s15/32").

(4 s12 or 5/32" s15/32")

Fig. 3-82

Screw

Fig. 3-83

VRF_Indoor_US.indb 29VRF_Indoor_US.indb 29 2011/09/30 12:23:072011/09/30 12:23:07

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 83 84

Komentarze do niniejszej Instrukcji

Brak uwag

Panasonic CZ-ESWC2 Instrukcja Instalacji Strona 29

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Klimatyzatory typu split Panasonic CZ-ESWC2